Help center / Guides
Self check-in when a tablet serves several amenities
If a kiosk tablet serves two or more amenities, a resident picks one before checking in. That keeps the head counts, the hours and the CSV honest for each place.
Set it up
Set up the kiosk as usual: turn on self check-in, choose how residents find their household and start kiosk mode on the tablet. Kiosk mode needs a gate PIN, so set one first. Then decide what the tablet serves. Under users and devices, the tablet's Amenities this tablet serves box defaults to all amenities. Pick the ones this kiosk should offer.
What residents see
After they find their household and say who is here, a Where are you going? question lists the amenities the tablet serves. The Check in button stays off and reads Choose where you're going until they pick one. With one amenity the question is skipped and the check-in goes to that amenity.
Rules follow the amenity
The guest limit on screen is the picked amenity's own limit, and the check-in is judged by that amenity's hours and rules. A kiosk check-in is saved with its amenity, so it shows in that amenity's head count and in the Pool column of the CSV.
If you change settings while the kiosk is running
Change a tablet's amenities while kiosk mode is open and a check-in at an amenity the tablet no longer serves is refused. The resident sees the message We couldn't finish that just now. Try again in a moment, or see the pool staff. rather than a staff-only instruction. The kiosk keeps its old list until the page loads again, so close kiosk mode and start it again after you change the tablet's amenities.
Closing kiosk mode
Closing kiosk mode takes the gate PIN, or the rotating one if you turned that on, so residents cannot get past the kiosk screen.